No.29 All Pau

After unpacking from this morning's dawn patrol, I hit the garage to get No.29 across the finish line.

I sanded the vent and leash plugs flush, and also the small resin patches I applied a couple of days ago.  Then I ran through the 80-120-220 sandings, followed by the 320-600 wetsanding.

Then I hung the board up and sprayed the clear coat all over the board.

Marlon and I ran some errands while the clear coat was drying.  Once we were back I measured out the deckpad.  This is a three piece - straight middle spacer with sides to match the asymmetry.

This one came out really nice.

I got the leash tie on, the marine deck sticky patches installed, and waxed the board up already.  I forgot to drill out the vent and install the vent plug - I'll do this before heading out tomorrow morning (to anoint this board!!!)