Friday, August 9, 2019

Catch Up Posts - Tuesday Template Making

I need to get these templates transferred and trimmed.  Primarily to clean up the garage again, but equally to get the new blank cut up.

Trying to maximize the usage of the 4x8 sheet - in some cases I'm making full length half templates as well as spin templates from the same paper template.

Going to get a wide 4'6" and a stubby 4'10" out of this blank.  Both will have tapered rear rails and tails.  This is a difference from the first two boards - and is in direct response to getting bogged down after the aft portions of the boards contacted the water.  Not sure how dramatic I'll make the back end chamfers, but we'll see together over the next several weeks.

No comments: