I sanded the bottom deck again - and there were a few pin holes that are still open (so yet another coat of epoxy goes on).
Then I went ahead of opened up the tracks.
I went ahead and mounted the drive and mast to gauge the plumbness of the bottom deck.
Relatively speaking, this looks straight. But if I stare at it long enough, it looks like it has an ever so slight lean to the right (looking at it this way).
I went ahead and added a thin layer of epoxy biasing to the right (and closing up the pin holes).
I'll sand again tomorrow. If it is good to go, I'll glue on the side offcuts and maybe laminate the bottom of the board (or finish shaping the top under where my rear foot will go). I'm trying to get this one across the finish line so it can get into the rotation.
No comments:
Post a Comment