I mowed the lawn and edged the back lawn. I also cleared the backyard of the plant debris that had been building up - then I hit the garage to do some shaping. This is No.39 - a 5'8" foil drive/winging board.
Here is the blank cut out from the billet foam.
And here it is rough shaped.
It's easier to dial the shape in when the sun is out and it is bright. I'll do this tomorrow.
And while I was in the garage, this is Prayot's AFS Pure 900. He drove it into the reef yesterday.
I had to pick sand and rock out of it. Then I sanded the areas that needed repair.
This will get fill and the tip will get a layer of carbon.
Filled and patch attached.
I'll trace the unscathed wing tip and get the patch grinded down to the same outline.
I'll need to add more epoxy to get this solid.
No comments:
Post a Comment