I got back to work on Roland's old Appletree board modification.
I try and remember to make sure I use my PPE...
I reconfirmed with Roland that he wanted the inserts more centered, and then cut away!
All cut!
And I also identified the delaminated areas -
And also got those cut out. Here's the board with the offcuts popped off.
The four rectangles were removed from bonded spots. You can see the delaminated offcuts - the foam separated and the foam is stuck on the offcut.
I'll get the delaminated areas built back up with carbon patches.
After that I'll route out the slots and get the blocks glued in.
Then I'll place carbon patches over the insert blocks.
Then I'll place a cap sheet over those to lock everything in.
No comments:
Post a Comment