After considering the amount of effort I need to put in to get the incorrectly set block cleaned up, I figured it might be best to reset it in the slot.
And here it is reset.
Since I had it on the ground, it was a good opportunity to look at the rocker - front
And back
I'll get the join areas cleaned up and get this ready for glassing.
I'm thinking carbon patches and fiberglass... (or maybe basalt - but with this planned to be a waxed front foot prone foiling board, basalt really wouldn't have a ton of benefit that an extra patch of fiberglass wouldn't provide - maybe better to save the basalt for a Foil Drive board).
No comments:
Post a Comment