This was work from yesterday.
I got Duke's board repair done. When I was sanding the repair down, I couldn't isolate the sanding to just the repair. So I ended up painting the area around the repair.
This was the big chip.
And this was the chip in the tail.
Then I sprayed paint onto the other side of the board to make the board look more symmetric.
And I went ahead and opened up the big Starboard Peanut board.
I'll have to fill this gap.
After I took this picture, I went ahead and place a layer of fiberglass and epoxy on the bottom of the slot.
I also trimmed more fiberglass to epoxy into the bottom of the reinforcement block - this board is big and the foil is going to apply a large moment arm to the board. And I can't use carbon because this board may be used with a Gen2 Foil Drive Max.
I'll add carbon over the top of this block - but using it underneath would have killed the signal transmission.
No comments:
Post a Comment