i was able to go to Lance's house today to use his hot wire cutter. We were able to split No.41 -
And I decided to skip out on the afternoon winds/waves to get some work done around the house (painting for La), and to go ahead and make some progress on No.41.
I measured, remeasured and adjusted the box location - I ended up moving it up about an inch. I used my projected feet positioning to figure out where the mast would go, then I made sure there was enough adjustability back and forward. This isn't the 16" thick box - so I wanted to be a little more accurate with placement.
And I got the box glued in.
I also measured and marked out the trench cut lines.
Tomorrow I'll trim off the excess glue, make the trench cuts, tape up the tracks, laminate the carbon strip that tops the tracks, and laminate the vertical sides of the trench. I'll do all this in the morning.
If the laminates settle in nicely, I'll glue the pieces back together to set the board up for the regular lamination. If I keep at it, this board may be done next weekend -
No comments:
Post a Comment