This is the board Bill got to me today - cracks in the top of the rails - both sides
I grinded the cracked epoxy out and prepared it for a fill with strips of carbon
And I prepped the patches for the trench board
Got them placed and then headed out to run errands
I sanded the Portal and then sprayed some clear coat on and that one was done.
For the Cruzer, I sanded, placed a fill coat, allowed it to harden, then came in and sanded the excess off.
Not the best job I've done, but with the repair so close to the deck pads it was the best I could do (without damaging the pads).
I loaded those two boards in the truck so I can return them to Bill tomorrow - and then I had a big empty space in the garage...
Now I can work on No.41 again. Since I had Bill's trench board (Amos Cruzer), I took some measurements from it and then marked up the cuts I'll need to make to get my version of a trench board put together.
Probably four extra steps needed to get the trench in place.
Here we go!
No comments:
Post a Comment