I sanded down the epoxy fill on these footstrap inserts this afternoon.
I also used a chamfer bit and opened up the area immediately around the insert center.
I'll drill out the hole tomorrow so I can rig a footstrap.
There were air bubbles I opened up when I sanded. I went ahead and filled those this evening.
I'll check on this in the morning before I go to work. Originally, I was going to put the deck pad cutouts back in place, but truthfully I think placing the footstrap right on top will be just fine. I could also check on the health of the plug just by looking at it. It might even be covered by the strap.
If the wind gets up to winging strength, I could test this out tomorrow (but if there is any winging to be done, it'll likely be on big stuff - North Mode Pro 6.8 or 5.5, Dragonfly 100l, AFS Enduro 1300).
No comments:
Post a Comment