After foiling, I got some work done on the two projects I have sitting in the garage.
On Matt's board, I cut out the bad parts and got it ready for splicing in the clean foam.
Here it is again all trimmed up.
I also got the track installed on Jim's board.
This was the dry fitting. I had to put this on pause because I had to go to work for a bit. When I got back, I went ahead and set them in with epoxy and added the first carbon overlay.
Tomorrow I'll sand the carbon overlay, add some fill around the boxes, then add the cap sheet. I should be able to get this done early next week (epoxy needs to harden).
I'll also try to rough shape the nose on Matt's board.
No comments:
Post a Comment