I got home and broke out the sander. I got the excess epoxy sanded off from around the plugs I installed on No.30.
There were some pin holes from air bubbles that got entrained in the plug fills. I filled those and will sand those flat tomorrow.
I also sanded the excess fill coat off No.31
It didn't go as fast as I thought it would - but I did get it done. I also drilled out the holes for the vent and leash plug. Before I headed out to the beach, I got the leash plug installed (that gave plenty of time for the epoxy to harden while the board was vertical).
Post foiling session I got the vent plug installed and I placed some epoxy on a few low spots I found while sanding the top deck.
Tomorrow I will go through the sanding regime, label the boards, maybe place a few paint accent marks, then spray clear coat. If I can get that far, these boards will be ready to take to the ocean this weekend!!!
No comments:
Post a Comment