Yesterday I sanded down one tip that was about a 1/16th taller than the other. Making sure the foil was distributed and complimentary to the untouched areas, I ended up barely exposing some core material again. I ended up using some JB Weld and patched up the over trimmed area.
Tonight I lightly sanded the cured JB Weld and felt much better about the results. I took the posca to the tip to dress up the sanded edge. And after several inspections, I finished with a coat of spray matte acrylic.
If the wind holds, I'm going to try this stabilizer out wing foiling (the tides are too low for prone foiling)
No comments:
Post a Comment