Block Slots Routed Out

I routed out the slots for the reinforcement blocks.  I didn't have access to one of my kids (Noe went sailing and Marlon drove La and Noe) so I did not use a vacuum to grab the offcuts.  There was foam particles everywhere - I looked like a snowman.

These slot were pretty good - a couple of oversized spots, but I think they can help get rid of any excess epoxy.  After I cut the slots, I went surfing with Marlon, so I'll epoxy these in place tomorrow.  That should set me up for cutting out the slots for the finboxes, epoxying those in, fine sanding the rest of the board, and putting on a seal coat. That will leave glassing for early next week and sanding later in the week.  A little bit everyday and this will get done.